Prolific Pl2303hx Driver
- Run PL2303 CheckChipVersion tool program in Windows XP/Vista/7 to check chip version. Windows XP, 2000, 98 and Windows ME driver technical support is discontinued. Prolific recommends to use PL-2303HXD (HX Rev D) or PL2303TA chip.
- The latest driver installed by Windows (Vista, 7, 8.1 and 10) is not compatible with these chips. The last compatible Prolific driver was v3.3.2.105. Windows may attempt to automatically load the Prolific driver 3.6.xx.xxx when inserting your cable.
- Prolific Full-Speed USB to Serial bridge controller PL-2303HX (Chip Rev A) and PL-2303X (Chip Rev A) will be phased out (EOL) at the end of October, 2012. Both will be replaced by the new PL2303TA which is pin-to-pin compatible with PL-2303HXA and PL-2303XA PCB. Please refer to the PL2303TA PCN, Datasheet, and Migration Guide for more information.
- D USB to Serial/UART Bridge Controller (Internal Crystal) The PL-2303HX is a low cost and high performance USB-to-Serial Bridge Controller. The PL-2303HX provides a convenient solution for connecting an RS-232 full-duplex asynchronous serial device to any Universal Serial Bus (USB) capable host.
はじめに Windows10標準ドライバ インストール後・・・ 対処方法 参考 はじめに 昔に購入したUSBシリアル変換ケーブル「Prolific PL2303」が、最新のWindows10で動作しなかったので、その対応方法の備忘メモです。 Windows10標準ドライバ インストール後・・・ Windows10標準ド. Artcam 9 jewelsmith software.
Download prolific pl2303 driver windows 10 and best Windows drivers: Dell Support Center, Wise Registry Cleaner Free, Uniblue RegistryBooster. The 2.0.3 version of PL2303 Windows Driver is provided as a free download on our website. This download was checked by our built-in antivirus and was rated as virus free. Nhl for mac free download. The software is sometimes distributed under different names, such as 'PL-2303 USB-to-Serial'. The software is categorized as System Utilities.
The PL2303RA chipset from Prolific can be found in a number of devices. The most common location for this chipset can be found in the USB to RS232 Bridge Controller which you will find in the StarTech 2 Port USB to RS232 Serial DB9 Adapter Cable. You can find the driver for this cable listed below as the Prolific USB to serial driver on this website.
PL2303RA USB to Serial Driver
The StarTech 2 Port USB to RS232 Serial DB9 Adapter Cable driver can be found below. This cable will allow you to add 2 serial RS-232 ports to any laptop or PC with a usable USB port available. This cable is a plug and play adapter however at times it may give problems which are discussed elsewhere on this website such as USB to Serial Error 39 as well as other errors such as common USB errors. This cable is fully compliant with the USB 1.1 specifications. Notice that these all use the same Prolific USB to serial driver on this website.
| Bus Type | USB 2.0 |
| Chipset ID | Prolific – PL2303HXA / Prolific – PL2303RA |
| Interface | Serial |
| FIFO | 192 Bytes |
| Maximum Data Transfer Rate | 230Kbps |
| Serial Protocol | RS-232 |
| Connector Type(s) | 1 – USB Type-A (4 pin) USB 2.0 Male |
| 2 – DB-9 (9 pin, D-Sub) Male | |
| System and Cable Requirements | 1 USB 1.1 (or above) port |
| Port Style | Cable Adapters |
Note the driver for the adapter is found below.
This will open to the installation pages.
USB to Serial Driver (Windows)
Pl2303hx Driver Windows 7
FT232r USB UART Driver (Linux)
Pl2303hx Driver Windows 10
Related Posts
Prolific Drivers
- Prolific USB to Serial Driver (1.000)
- Gigaware USB to Serial Driver (1.000)
- Aten USB to Serial Driver (1.000)
- Bafo USB to Serial Driver (1.000)
- Prolific USB to Serial Comm Port Driver (1.000)